From d6b957857faf7511dbf6692e27ab1f18bf22f362 Mon Sep 17 00:00:00 2001 From: James Churchill Date: Mon, 27 Jun 2016 16:40:13 +1000 Subject: [PATCH] Fix second half of table --- HamShield-Serial-Mode.md | 28 ++++++++++++---------------- 1 file changed, 12 insertions(+), 16 deletions(-) diff --git a/HamShield-Serial-Mode.md b/HamShield-Serial-Mode.md index 1cd9208..94734fd 100644 --- a/HamShield-Serial-Mode.md +++ b/HamShield-Serial-Mode.md @@ -20,20 +20,16 @@ HamShield Serial Interface Commands CDCSS OutH[code];Code must be a valid CDCSS code Print ConfigIPrint out all configurations in comma delimited format. Power LevelP[level];Set power amp level, 0 = lowest, 15 = highest +Enable OffsetR[state];1 turns on repeater offset mode, 0 turns off repeater offset mode +SquelchS[level];Set the squelch level +TX OffsetT[freq];The absolute frequency of the repeater offset to transmit on in KHz +VolumeV[level];Set the volume level of the receiver +ResetXReset all settings to default +SleepZSleep radio +Filters@[state];Set bit to enable, clear bit to disable: 0 = pre/de-emphasis, 1 = high pass filter, 2 = low pass filter (default: ascii 7, all enabled) +Vox mode$[state];0 = vox off, >= 1 audio sensitivity. lower value more sensitive +Mic Channel*[state];Set the voice channel. 0 = signal from mic or arduino, 1 = internal tone generator +RSSI?Respond with the current receive level in - dBm (no sign provided on numerical response) +Tone Gen%[notes]To send a tone, use the following format: Single tone: %1,[freq],[length]; Dual tone: %2,[freq],[freq],[length]; DTMF: %3,[key],[length]; +Voice Level^Respond with the current voice level (VSSI) - -Enable Offset R; 1 turns on repeater offset mode, 0 turns off repeater offset mode No -Squelch S; Set the squelch level No -TX Offset T; The absolute frequency of the repeater offset to transmit on in KHz No -Volume V; Set the volume level of the receiver No -Reset X Reset all settings to default No -Sleep Z Sleep radio No -Filters @; Set bit to enable, clear bit to disable: 0 = pre/de-emphasis, 1 = high pass filter, 2 = low pass filter (default: ascii 7, all enabled) No -Vox mode $; 0 = vox off, >= 1 audio sensitivity. lower value more sensitive No -Mic Channel *; Set the voice channel. 0 = signal from mic or arduino, 1 = internal tone generator No -RSSI ? Respond with the current receive level in - dBm (no sign provided on numerical response) No -Tone Gen % (notes) To send a tone, use the following format: Single tone: %1,,; Dual tone: %2,,,; DTMF: %3,,; No -Voice Level ^ Respond with the current voice level (VSSI) - - -` \ No newline at end of file