Fixed FMBeacon example, required slight modification to library. TO-DO notes in example header.

examples/FMBeacon/FMBeacon.ino

@@ -3,16 +3,18 @@ Morse Code Beacon
 
 Test beacon will transmit and wait 30 seconds. 
 Beacon will check to see if the channel is clear before it will transmit.
+
+TO-DO: Radio chip audio AGC too slow in responding to tones, worked around by playing a 6khz tone between actual dits/dahs.
+Should work on adjusting AGC to not require this.
 */
 
-// Include the HamSheild
+#define DDS_REFCLK_DEFAULT 9600
 #include <HamShield.h>
 
 #define PWM_PIN 3
 #define RESET_PIN A3
 #define SWITCH_PIN 2
 
-// Create a new instance of our HamSheild class, called 'radio'
 HamShield radio;
 
 // Run our start up things here
@@ -42,8 +44,9 @@ void setup() {
   // Tell the HamShield to start up
   radio.initialize();
   radio.setRfPower(0);
+
   // Configure the HamShield to transmit and recieve on 446.000MHz
-  radio.frequency(145570);
+  radio.frequency(438000);
   
   Serial.println("Radio Configured.");
 }
@@ -60,13 +63,13 @@ void loop() {
     radio.setModeTransmit();
     
     // Send a message out in morse code
-    radio.morseOut("KC7IBT ARDUINO HAMSHIELD");
+    radio.morseOut(" KC7IBT ARDUINO HAMSHIELD");
     
     // We're done sending the message, set the radio back into recieve mode.
     radio.setModeReceive();
     Serial.println("Done.");
     
-    // Wait 30 seconds before we send our beacon again.
+    // Wait a second before we send our beacon again.
     delay(1000);    
   } else {
     // If we get here, the channel is busy. Let's also print out the RSSI.