Removed JustTransmit example. It doesn't add anything not covered in other basic examples like FMBeacon or HandyTalkie

examples/JustTransmit/JustTransmit.ino

@@ -1,51 +0,0 @@
-/* Hamshield
- * Example: Just Transmit
- * This example continuously transmits.
- * Connect the HamShield to your Arduino. Screw the antenna 
- * into the HamShield RF jack. Plug a pair of headphones with 
- * built-in mic into the HamShield. Connect the Arduino to 
- * wall power and then to your computer via USB. After 
- * uploading this program to your Arduino, open the Serial 
- * Monitor to monitor the program's progress. After setup is 
- * complete, tune a HandyTalkie (HT) to 144.025MHz. Listen on 
- * the HT for the HamShield broadcasting from the mic.
-*/
-
-#include <HamShield.h>
-
-#define PWM_PIN 3
-#define RESET_PIN A3
-#define SWITCH_PIN 2
-
-HamShield radio;
-
-void setup() {
-  // NOTE: if not using PWM out, it should be held low to avoid tx noise
-  pinMode(PWM_PIN, OUTPUT);
-  digitalWrite(PWM_PIN, LOW);
-  
-  // prep the switch
-  pinMode(SWITCH_PIN, INPUT_PULLUP);
-  
-  // set up the reset control pin
-  pinMode(RESET_PIN, OUTPUT);
-  digitalWrite(RESET_PIN, HIGH);
-  
-  Serial.begin(9600);
-  Serial.println("If the sketch freezes at radio status, there is something wrong with power or the shield");
-  Serial.print("Radio status: ");
-  int result = radio.testConnection();
-  Serial.println(result,DEC);
-  Serial.println("Setting radio to its defaults..");
-  radio.initialize();
-  radio.setRfPower(0);
-}
-
-void loop() {
-  radio.bypassPreDeEmph();
-  radio.frequency(144025);
-  // radio.setTxSourceNone();
-  radio.setModeTransmit();
-  for(;;) { }
-}
-