Kyle Isom
777c4529c2
|
||
|---|---|---|
| .. | ||
| Makefile | ||
| README.md | ||
| SegmentLCD.v | ||
| TinyAdder.v | ||
| apio.ini | ||
| install_apio.sh | ||
| pins.pcf | ||
| tinyadder_r2.brd | ||
| tinyadder_r2.sch | ||
| tinyadder_r3.brd | ||
| tinyadder_r3.sch | ||
README.md
TinyAdder
TinyAdder is a 4-bit adder built on the TinyFPGA BX. It connects four slide switches (I wanted actual toggle switches, but that's how it goes) to a pair of 7-segment LCD displays.
Code organisation
Currently there are two modules:
- SegmentLCD: a little awkwardly named due to the naming constraints, but this takes a 4-bit input number and outputs a 7-bit output. The hookup requirements are described in the module comments.
- TinyAdder: This is the top-level adder.
Hardware revisions
- rev1 (2018-12-22)
- rev2 (2018-12-22): realised that the LCDs were missing resistors; I had been looking at a tutorial that used a shift register; the shift register apparently had an internal current limiter so I assumed the LCDs didn't need them. This was wrong. Fortunately I was able to cancel the rev1 order before it went out.
- rev3 (2018-12-28): after breadboarding the push button, I realised I'd messed up the schematic (and accordingly, the board) by wiring both ends of the push buttons to Vcc, which... isn't very useful at all. I fixed it, but not before the rev2 was sent to the fab.
TODO
- I'd like to have the two displays show the two numbers before adding them. The 'hi' display could show the first addend, and the 'low' could show the second addend, with live updating.